Americas
Asia-Pacific
Europe
South Asia, Middle East & Africa
Restoring OEM seams is an art in itself. But with our TEROSON® Seam Sealing system it is actually easy to replicate the original OEM structure. Learn everything you need to know about seam sealing in vehicle body repair from the use of standard beads to reproduction of OEM textures.
In vehicle repair it is crucial to reproduce the same quality and visual appearance provided by the original OEM seams to avoid corrosion. With the below instruction you can recreate ribbed beads using flatstream or widestream (acoustic) beads.
All repair and maintenance tasks shown should be done by professionals only. Please do not try this at home or if not qualified by professional education. Always follow car manufacturer's instructions.
Limitation of liability
Heating the product allows easy application at lower pressure and smooth texture. Pre-heat cartridges in the heating device (max. 60°C).
NOTE: Remove bottom lid from cartridge before heating.
Remove all contamination from the surfaces and pretreat the sealing area with TEROSON® VR 10.
Remove bottom cover and open cartridge. Screw on nozzle tightly.
Insert cartridge and adjust nozzle to working position. Horizontal or vertical application. Use the stabilising ribs for guidance during application.
Adjust main air pressure on supply unit to between 6 bar (min) and 10 bar (max). Adjust application pressure on TEROSON® ET GUN POWERLINE II handle.
To create a flatstream bead hold application gun at a distance of 6 to 12 cm from the surface. Adjust pressure to 6 to 12 bar with TEROSON® ET GUN POWERLINE II, depends on recommends width of OEM.
Before applying sealant, tape beginning and end of the application area. Remove the masking tape before the beads form a skin. Create a widestream bead (to reproduce acoustic applications) with a size of 8 to 12 cm in width, adjust the working pressure at 15 to 22 bar and distance the nozzle to surface of 8 to 12 cm.
There are different application tools that can simplify the application. E.g. the flexible hose allows you to work even in areas with minimal space. A spacer can be used to keep equal distance to the surface or to guide along the edges.
ANSWERS TO YOUR MOST COMMON QUESTIONS
Limitation of Liability
The information provided herein, especially recommendations for the usage and the application of our products, is based upon our knowledge and experience. Due to different materials used as well as to varying working conditions beyond our control we strictly recommend to carry out intensive trials to test the suitability of our products with regard to the required processes and applications. We do not accept any liability with regard to the above information or with regard to any written or verbal recommendation, except if otherwise explicitly agreed and except in relation to death or personal injury caused by Henkel´s gross negligence or intention and any liability under any applicable mandatory product liability law. Please note that the information provided by us may not be current, complete and correct. It is not intended to serve as legal advice. Each user is solely responsible for assessing and ensuring compliance with any applicable law. The information is protected by copyright. In particular, any reproductions, adaptations, translations, storage and processing in other media, including storage or processing by electronic means, enjoy copyright protection. Any exploitation in whole or in part thereof shall require the prior written consent of HENKEL ČR, spol. s r. o. Except as otherwise noted, all marks used in this sell sheet are trademarks and/or registered trademarks of Henkel and/or its affiliates.
