LOCTITE® 567 - Tube 10.0/case
Features and Benefits
Available sizes:
- Ideal for metal pipes and fittings
- Provides an instant low pressure seal
- NSF/ANSI 61 certified for potable water systems
- UL MH8007 & ULC MH27131 classified for natural gas systems
- Meets KIWA GASTEC QA AR 214 performance requirements for hydrogen gas systems
- Single component - clean and easy to apply
- Doesn’t creep, shrink or block systems
- Thixotropic and high/very high viscosity
Documents and Downloads
Looking for a TDS or SDS in another language?
Technical Information
Agency approvals / certificates / specifications | UL |
Applications | Pipe sealing, Thread sealing |
Breakaway torque, Steel M10 | 12.0 N·m (110.0 in./lb. ) |
Colour | Off white |
Cure type | Anaerobic cure |
Key characteristics | Immediate low pressure sealing, Oil tolerant, Strength: low Strength, Temperature: high temperature, Thixotropic |
Operating temperature | -55.0 - 200.0 °C (-65.0 - 400.0 °F ) |
Physical form | Paste |
Recommended for use with | Metal, Metal: aluminium, Metal: steel - galvanized steel, Metal: steel - stainless steel, Thread type: coarse, Thread type: tapered |
Viscosity, 20 RPM | 540000.0 mPa·s |
How to
Step by Step Guide
1. Preparation
Cleaning - It is recommended to use LOCTITE® SF 7063/7064 to degrease and clean surfaces prior to applying adhesive. If cure speed is too slow due to passive metals (stainless steel, aluminium and plated metals) or low temperature (below 5°C), apply activator LOCTITE® SF 7240 or LOCTITE® SF 7649 (see cure speed vs activator graph in the TDS).
2. Preparation - Activation
If cure speed is too slow due to passive metals (stainless steel, aluminum and plated metals) or low temperatures (below 5°C), use LOCTITE® SF 7649 activator. Allow to dry.
3. Application
Apply a 360° bead to the leading male thread, leaving the first thread free. For bigger threads, apply both on male and female threads. For manual dispensing the use of a peristaltic handgun is recommended to ensure a consistent application volume.
4. Assembly
Assemble fittings using wrench tightening in accordance with manufacturers' recommendations.
Disassembly
Disassemble with standard hand tools. If not possible, apply localised heat to approximately 260°C and disassemble while hot. For corroded or seized parts, use LOCTITE® LB 8040 Freeze and Release.