LOCTITE® 277

Features and Benefits

Designed for high-strength, permanent locking and sealing of large threads greater than 25mm (1").
LOCTITE® 277 is a red, high strength, high-viscosity threadlocking adhesive especially suitable for large bolts and studs greater than 25.4 mm (1"). Disassembly with heat possible.
  • High torque strength
  • High viscosity
  • Prevents unwanted movement, loosening, leaks and corrosion
  • Can be disassembled by heating parts to 300°C (572°F)
  • Meets Mil Spec: MIL-S-46163A Type I Grade L
Read More

Technical Information

Application method Dispense gun, Dispense system, Manual
Application temperature -55.0 - 150.0 °C (-65.0 - 300.0 °F )
Applications Threadlocking for large bolts / studs
Breakaway torque, M10 Steel Nuts/Bolts 32.0 N·m (280.0 in./lb. )
Color Red
Cure type Anaerobic cure
Fixture time 45.0 min.
Key characteristics Fluorescent, Strength: high strength, Thixotropic
Physical form Liquid
Prevail torque, M10 Steel Nuts/Bolts 32.0 N·m (280.0 in./lb. )
Recommended for use with Metal: brass, Metal: steel, Metal: steel - stainless steel
Viscosity, 20 RPM 7000.0 mPa·s (cP)

How to

Step by Step Guide

1. Preparation - Cleaning

It is recommended to use LOCTITE® SF 7063, SF 7064 or SF 7070 to degrease and clean surfaces prior to applying threadlocker.

2. Preparation - Activation

If cure speed is too slow due to passive metals (stainless steel, aluminum and plated metals) or low temperature (below 5°C), use LOCTITE® SF 7240 or SF 7649 activator. Allow to dry.

3a. Application - Through Hole

Apply a few drops of liquid threadlocker to the thread engagement area. Assemble nut and tighten to proper torque.

3b. Application - Blind Hole

Apply several drops of liquid threadlocker into lower third of blind hole, as well as a few drops onto male threads, and then install male threads. Tighten to proper torque.

4. Assembly

Assemble and tighten to proper torque requirement. If several bolts are being assembled, torque them down to the correct value within the fixture time window.

5. Disassembly

If disassembly is not possible using normal hand tools, apply localized heat to approximately 500°F/260°C. Disassemble while hot with standard hand tools.

Equipment

For manual dispensing, the use of LOCTITE® EQ Pro Pump (for 50ml and 250ml bottles) or LOCTITE® Peristaltic Hand Pumps (50ml or 250ml versions) is recommended to ensure a consistent application volume.

Hint

For the disassembly of corroded or seized parts, use LOCTITE® LB 8040 Freeze and Release.

Frequently Asked Questions