LOCTITE® PC 7383
Features and Benefits
- 100% solid - no sagging or slumping
- High abrasion, impact and chemical resistance
- Protects both rubber and metal surfaces
- Easy to use - trowelable and thixotropic
Documents and Downloads
Looking for a TDS or SDS in another language?
Technical Information
Application method | Trowel |
Applications | Rubber repair |
Cure type | Room temperature (ambient) cure, Two component mix |
Key characteristics | Abrasion resistant, Impact resistance: high, Renews worn surfaces, Sag: non-sag |
Physical form | Paste |
Recommended for use with | Metal, Rubber |
How to
Step by Step Guide
1. Preparation - Metal Surfaces
Remove dirt, oil, grease, loose flaky rust, etc., with a suitable high pressure water cleaning system using LOCTITE SF 7840 cleaner/degreaser.
2. Preparation - Rubber Surfaces
Remove all loose and damaged pieces of material from the repair surface such as old rubber, fabric, etc. Abrade the repair area with an abrasive wheel, being sure to avoid overheating and melting of the rubber.
3. Mixing
A corded drill with mixer attachment can be used for mixing. Pre-mix the resin for 1 minute. Add the hardener into the resin and mix thoroughly until there is a uniform color and consistency. Be sure to scrape the sides and bottom of the pail.
4. Application
Apply a thin amount of the coating onto the repair area and work the product into the surface with a trowel, spatula, or gloved hand, to ensure good adhesion and to avoid bubbling. The coating can then be built up to the desired thickness required.